• 5 Auto Paint Restoration Tips of the Pros

    Getting a completely even coat of paint while carrying out auto paint restoration on a car is not easy. It does require a steady hand and a lot of practice. You may be using a can or a compressor, but with a little help from the professionals in the form of auto paint polishing tips, you should be able to do a great job.

    1. Mix the Paint Well

    There are chances that the paint pigments have separated during storage and you could initially end up with a film of transparent turpentine. Make sure that the paint is adequately mixed. As a further precaution, use the gun on another surface for three minutes to get the right concentration of paint.

    2. Hold the Paint Gun the Right Way

    Make sure that you’re holding the paint gun the exact distance from the surface as indicated by the paint manufacturer. The reason for this is that most paints are calibrated to sit on the surface without clumping or drying if you use the right distance. This distance is tested by manufacturers to get the best spray pattern, and it will provide the best distribution of paint on the surface. For example, spraying the paint from too close will cause the paint to clump and run, while spraying from too far away will cause the paint to dry, leaving a dull finish to the surface.

    3. Move the Spray Gun at the Right Speed

    If you don’t move the spray gun at the right speed when painting, the paint clumps up again. Usually when you see the paint spread out and wet the surface, you have to move the paint gunn evenly to another location. Applying it too thick makes it run and applying it too thin will make it float off the surface.

    4. Spray the Paint Parallel to the Surface

    To get the necessary thickness and depth of paint, you will have to apply two or three coats. The first coat has to be placed carefully and the next one has to be done on top of the first tacky or sticky coat to get the best results. The idea is that the first coat is still soft and uncured. As a result, the new second coat will stick better, melt the first coat again and allow more depth of color to the car.

    5. Prepare the Surface Well

    Many people underestimate the surface preparation that is involved before painting a car. Make sure that you complete at least 95% of the surface smoothing and polishing before you start with any painting. If you are just planning a touch up to the surface, a simple surface preparation will do. A complete color change will require preparations of the door jambs, engine compartment and interior of the car. You might have to remove the engine to make sure that the interior matches the exterior of the car. Another point to remember is that no matter what you are using to paint the car, check the shade density of the auto paint restoration products under several lights to make sure that the color you choose is the one you will eventually like.