How to Install and Combine a Car Radio CD Changer to Your System
Whenever you are installing a car radio CD changer, you will find that there are a few ways that you can go about it. You will find that a CD changer in your car is a great way for you to be able to enjoy all of your discs without having to worry about taking out one CD and putting a new one in. You will need to make sure that the CD changer you choose is compatible with your vehicle.
- Power Cord
- CD Changer
- FM Adapter
- CD Changer Kit
Step 1 – Location
The first thing that you are going to have to do is decide on the location for your car stereo CD changer. Usually, these are put either underneath one of the seats or in the trunk. It will usually depend on the type of vehicle you have as well as what your skill level is. You will need to think about the cabling paths and how easy they will be whenever you are choosing the location.
Step 2 – Hook Up
Think about how the best way to hook up your compact CD changer to the stock unit that is already in your vehicle. A lot of older vehicles are not going to have any type of output jacks that will allow you to have any extra equipment. If this is the case, then an FM adapter will be necessary. This will work by allowing you to play the CD changer through the radio frequency you have chosen.
Step 3 – Cabling Path
You are now going to need to find a cabling path. This path is going to be for your power cord for your CD changer. It will go between the main unit in your dashboard and the location where the installation is taking place. You will need to make sure that the cord is long enough and also that it can easily be hidden. Your goal is to prevent people from seeing and tripping over it.
Step 4 – CD Interface
It is important that you check to see if the radio already has an interface. This is going to help determine where you are going to end up plugging in the new CD changer. If there is not an existing CD interface, then you are going to need to run brand new leads going into the back of your stereo.
Step 5 – Install
You are now ready to install the unit with the mounting hardware. You will be able to choose between Velcro straps and brackets that will be screwed into the floor. Make sure that you have your screwdriver out so you can get the brackets properly fastened. You will also need the screwdriver so you can reinstall and remove the carpeting for whenever you are putting the power cord down. Make sure that whenever you are putting the carpeting back down, that it is secured so no debris can get underneath it.